Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs

Split Wishbone Heavy Duty TRE and Weld Bungs

$53

As 1935 and later cars and trucks became bigger and heavier it is a good piece of mind to use heavy duty Tie Rod Ends and Weld Bungs when splitting your wishbones to make way for a new hot rod engine / transmission.

These Tie Rod Ends are 3/4-16 thread and retain a 7 degree taper. However this 7 degree shaft is thicker than those on 11/16" TRE's and modified or correct frame tabs are recommended. 

Frame Tabs # 001-60527

Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Split Wishbone Heavy Duty TRE and Weld Bungs
Back